Centrifugal Pump | Parts | Working | Diagram

In Todays article we are going to discuss about Centrifugal Pumps , its parts and how it works. Also we will be discussing about...

What is Tappet Clearance ? How to check and Adjust Tappet Clearance ?

Here,we will discuss about the importance of Tappet Clearance of the Inlet and Exhaust valve in four- stroke Diesel engine.

Heat Exchanger – Types | Working | Construction

Heat Exchanger In todays article we are going to discuss about the Heat Exchanger. By the end of this...

Propeller Drop

What is Propeller Drop ? Propeller Drop is distance,drop due to its own weights. Due to the weight of propeller and the clearance developed due to...

How does the emergency generator start automatically ?

How does the emergency generator start automatically ? It is activated by a under voltage relay. When there is blackout, the under voltage relay senses...

Oily Water Separator : Construction, Working Principle, How It Works ?

Have you any doubt related oily water separator? Don't worry ! In this article, I have added answer of all questions arises related to this...

What is a shaft generator ?

What is a shaft generator ? Shaft Generator is an alternator driven by main propulsion unit through clutch and gearing to produce electricity. It can be...

Safety Devices of All marine Equipment

Safety Devices of all Marine Equipment used on board are mentioned here. What is Safety Device ? A safety device is a piece of...

How Vaccum is created in fresh water generator ?

How Vacuum is Created in fresh water generator ? In This Article,I have added How Vacuum is created...

How do I clean fuel oil duplex filter on ship

Purge the standby filter before changing over. Changeover the filter. Drain the filter which was in use. Slacken the nut, and make sure there's no residual pressure...